Interior/Exterior Paint Application
1. Prepare the surface
- Wash down chalky surfaces with sugar soap solution and then rinse with clean water.
- Flaky, crazed or peeling paint needs to be scraped or sanded before applying top coats.
- Fill cracks, nail holes, etc with Gap Filler and then spot prime when dry.
- If painting over any oil based finish, a primer sealer coat will need to be applied to ensure the paint has a key-grip to the surface and to prevent tannin bleed. Zinsser Smart Prime is the best product for this. Gloss Off may also be suitable product.
- If painting onto old pre-painted surfaces do an Adhesion Test. Take a blade and make a cross incision into to paint. Place a piece of standard masking tape over the incision press down. Peel off the masking tape and if any paint comes away then the surface is unsound and needs to be removed (scraped or sanded before applying top coats).
- Always do a test patch to check adhesion, finish and tannin bleed.
- Stir paint prior to application to ensure all pigments and ingredients disperse evenly.
- Wet down and shake out brush and roller sleeves with water before dipping into paint.
- Clear the area to be painted and make sure there is nothing in your way.
- Cover any exposed furniture or floors with a drop sheet.
- “Cut in” edges first with a brush and then roll the rest.
- Do one section of wall at a time so cut in edges stay wet and blend in with the rolled area.
- Start at the top and work your way down.
- Work consistently in one direction.
- Rolled areas need to be “laid off” (gently rolled in one direction – usually up the wall) while the paint is wet so that the sheen level remains consistent.
- Paint will be touch dry in 30min. Allow 2 hours between coats or longer in humid or cold/damp conditions.
4. Post Painting
- If you are leaving the job and want to continue sometime later load the brush or roller in paint and then wrap them individually in plastic to keep them from drying out. This saves washing.
- Always wipe excess paint from the rim of the pail and seal lid tightly. If the lid is not sealed correctly a skin will form on top of the paint and the paint may go off. Store out of direct sunlight in a cool place. If paint has been stored for a period of time do not shake. Always remove lid and stir paint. This will prevent any dry paint on the lid from mixing into the wet paint.
- On completion wash brushes and rollers out in warm soapy water and hang to dry before storing. Roller trays can be left and when paint skin is dry paint can be peeled off and disposed of easily.
- Wash out empty paint buckets and recycle. We use plastic pails as they can be easily washed out and used around the home rather than be thrown out after a single use.
- Dispose of waste responsibly.